tpi chevy 350

[Marty G]

any one hear done a tpi conversion ?

[1-tonmudder]

I started to,but went with a TBI.

[Marty G]

no one this is a suprize im starting to build up parts to try it next winter on my toyota project
going to build it carberated for now get the bugs out and try to enjoy it this summer
every time i do a search for building low end torq with a chevy 350 i find tuned port injecton sites.

[Hokie_YJ]

I wanna build (more like have built) a TPI stroker. :smokin:

[pplblazerdude]

I wanna build (more like have built) a TPI stroker. :smokin: id like to hear more about this

[Hokie_YJ]

Jusr dreaming a little. :lol:

[HotRodYJ]

Marty if your looking for low end torgue, stroke it to a 383 when you do the build.

[Marty G]

thats in the later plan too
for now it will be a stock 350 though :cry:
i hafe to stay on a budget so i can aford to finish it

[Andy's01]

I have a 5.7L out of a 99 tahoe that I have in the engine shop as we speak. All I am doing to it is putting a Comp Cam and new valve springs and rockers and the numbers on the Comp cam software but the rear wheel numbers to roughly 370ph (4300rpm) and 509 ft/lbs (2800rpm). So I chose to do this instead of stroking it. Now, I may go back later and stroke it but I would think that these numbers will really make my jeep stand tall if I need it to.

[Hokie_YJ]

I wanna build (more like have built) a TPI stroker. :smokin:

Almost a year later and I'm halfway there. :icon_mrgreen:

I just ran across this old post while I was doing some searching, thought I'd drag it back from the dead. :icon_lol: